Search results

Sorry wrong post..........

OK, The Manrose Fan has arrived ready for fitting. My bathroom is approx 35cm x 35cm x 24cm H. The fan fitted in ceiling in zone 1, half over shower and half outside cubicle. Of the 3 settings for speed/extraction rate, which do you find is best with a overrun of approx 10/15mins.

We had extra insulation put down in the loft at 20cm deep (InstaFibre roll) some years ago. 2 years ago we had 4 extra roof vents with ever increasing summer temperatures. At same time the roof felting along the soffit edges was replaced, adding the soffit cement boards were replaced with upvc...

Reading and viewing various clips on YT etc. Finally decide on a Manrose inline with timer - MF100T fan

Waste of time, shortly after when the new suite was installed and running. We had a water leak from the mixer valve damaging the new composite type flooring as recommended by them, although they would only replace as existing flooring. Contacted Head Office/CEO, eventually managed to have proper...

As we have a separate pull cord switch with an indicator light for the extractor fan would I need a timer type fan, as we have a gravity type shower from a hot water cylinder. Using the pull cord switch, can the timer be used as long as the switch is left on ? With the condensation trap, can...

Thanks, The flexi pipe goes up into the loft across to the soffit and exits through a grille. Checked the flexi and it lies uncovered across the loft and drops down to the soffit outlet as its lower than the loft floor.. Would it help as I have a spare roll of insul/material to lay a covering...

2021 we had the bathroom refurbd complete with new floor, wall tiles, shower etc etc. by High street store, subcontracted to a local trades person. The fan a Vent-Axia 446659B vasf 100t, used as a manual on/off not timer, vented to the roof eaves. The fan was ceiling fitted above the shower...

Read lots of posts about shower pump pipes 15mm or 22mm, not truly near full bore with restrictions. My inlet pipes to pump are 22mm, but I want to make my own pipes to ensure full bore as 22mm copper pipe with 20mm id Found fittings etc to fit pump and pipe allowing full bore to the inlets...