Search results

Morning, I created a fall around the roof lantern but by the time I've attached the EPDM sheets the corner joins are stopping water falling away, can any offer any advice how I can make this good? Or shall I cut section away and start again?

thanks for your suggestion, think i'll ask the SE some questions as you have said. no load weight on these, just the timber frame walls, load weight is on the steels that run above.

Hi, can any help, I need to use M12 self drill screws to steel post, see detail from the SE. I've not been able to find M12 self drill screws! Has anyone dealt with this type of attachment before? Cheers Will

Thanks Hugh and Ivor. Think concrete is a good idea, just wanted to get it right before the BC inspector visits site. Thanks again

Hello, can anyone help with this question, I've got some 110mm underground waste pipe that are just below the hardcore of my extension, i can't lay the pipe any lower because of the fall of the main waste pipe. I don't want to lay hardcore on top of the pipe as I'm worried it could piece the...

Thanks, I did try but need the gully in the corner to near to the chamber to get the trap done!

Hello, I've had to go back on myself with the underground drainage, does anyone know if this is ok? Water flows fine, it's 1:40 fall, but not sure if it's with regulations?

Ok thanks, I'm not sure I understand how to leave them in a pocket, was going to build over them, once painted with the high build bitumen paint, with the mortar, so I have a continued cavity wall to build up the timber walls, from dbm, and for the floor hangers! if that makes sense?

Thanks. Its a timber frame after the cavity wall, see picture. hope that makes sense?

Does anyone know if I can build over the base plate on a steel column which is bolted to foundations? Would it need a lintel or just motor and block work? any help would be great. I do know this needs to be painted with high build bitumen paint as well. the picture below shows the columns in...

Ok, that makes sense, I'll have another look tomorrow to amend it, thanks for your feedback. Just want it right before BC review it

Hello, I've drawn this plan for block and brick work up to timber suspended floor, does anyone know if this looks ok? Thanks Will