Search results

I have been wallpapering using Anaglypta Argo paintable wallpaper and panting with Dulux Matt emulsion in “sail white”. I am finding the painting is drying patchy in areas and appears more when looking across the wall, so I think it’s some of the edges of the embossed pattern. I’ve already...

I’ve found the the Ronseal High Performance one and that gets good reviews, and it’s 2 part so that should do the trick

What would you recommend to use to fill screw holes in MDF skirting?

My walls have been skimmed, with some bonding in places first, and I will be fitting MDF skirting using mostly grab adhesive. How long should I wait for the plaster to dry before fitting, and is there any need to seal the wall before fitting?

They are proper blocks, but if drilled them before without hammer so will do that again.

Later this week my living room will be plastered and I will be fitting new 14mm MDF bullnose skirting. I will be using grab adhesive but don’t want to fully rely on this so will use screws and plugs too. My walls are grey blocks. Which size screws and plugs would you recommend?

Thanks I know what it’s for and where it goes, just don’t know whether or not I can pull it away from the wall. Maybe I just tell the plasterer to stay away from it.

I am about to have my walls skimmed and need to know how I take these two bits off the wall. I assume the square box just lifts off screws, but does anyone know how to remove the round bit just so the plasterer can get behind it?

I have recently had some plastering done to walls and ceiling. These will be wallpapered using blown vinyl and patterned paper. Previously I have used a watered down wallpaper paste to seal the walls but this has always been hit and miss, and not sure if there is anything better to use. Can I...

No we don’t. The internal wall is flat so no chimney breast, it’s all outside.

It would be Sky Q box, Xbox etc, so not an option to mount behind

Ok I will use 135 degree bends then and trim flush with the wall, and perhaps cover with brush plates just for a neater finish.

Actually the plumbing pipe idea would work great. I’m thinking a 90 degree fitting on each end of a short length of pipe buried in the wall with the fitting flush or even slightly proud of the finished wall.

I am putting tv on the wall above a unit and don’t want any cables visible

This stuff? can you recommend a particular brand?

What’s the best way of fitting new skirting to plaster and brick/block walls?

Sorry about positive/negative. I mean L and N.

I have just taken down a light in our living room ready for plastering and there are 3 red wires all together in a connector block, so I put these in a wago. Then there is 2 black wires that were in one light terminal and 1 black wire in the other light terminal. When I put the new light up...

I am looking for ideas of how to get HDMi cables up a wall about 1 meter to where the TV is going. Walls are plaster and brick, but will be getting skimmed again as I have a socket to put in that area too. I’ve seen wall plates, nylon covers etc but what’s your opinion? Thanks

Yes I am aware of this, and the new socket will be a spur from the input on the FCU but then the new socket will never spur to anything else. The next big job I need to do in a few weeks is to connect a new FCU from an existing socket then connect four double sockets from the FCU radially (if...