Search results

The fan was working (as I ran the cycle with the lid off and watched it)and the pump was discharging the water (I put the drain pipe into an elevated bucket as you suggested). The repair guy said it must be the programmer/electronics not operating things at the right time and as the replacement...

Has anyone had a problem with this model leaking water. It appears to be leaking from near the front. I'm asssuming that it will be the door seals that need replacing. Can anyone advise :?:

I ended up taking into a repair shop and they checked evrything and couldn't find the fault. They said it must be in the programming/electronics and I may as well buy a new machine considering how much it would be to replace the programmer. Oh well, I had a go! :(

I took the coils / valve off, had them checked by an engineer and they are in good working order. There is also 240volts going to the coils during the cycle so the valve will be opening. I still have the problem & I'm really stumped now! Has anyone got any further ideas that I can check out :?:

Well, I managed to take the casing apart and clean the clogged condenser. However, I am still experiencing the same problem. :( The drier runs through a complete cycle but the washing is hot and damp. When I try to run the cylce again I get an E10 error message which is apparently to do with...

Thank you both for your help :D I'll give it a go and hope I don't come unstuck :? Thanks

Thanks for the info. Do you know of any schematic diagrams available on the net that show how the machine casing comes apart ie which bolts have to be undone etc?

My Zanussi 1257S goes through a dry cycle and the clothes come out very hot (steamy) but still damp. From the other posts it sounds like it could be a blocked condenser. Does anyone know where the condenser is on this model and the procedure to access/clean it? Also, I've read another post...