Search results

Not quite. As mdpe comes out if the floor, replace the current brass stopcock with a 25mm elbow mdpe pointing to your 15mm copper and use the reducing set to attach the copper to the elbow. Then... Cut in a 15mm lever valve on the 15mm copper. You don't need the additional adaptor, the...

IME, if your main is copper from street to house then adandon it. It will likely be failing in several places and as each leak is repaired, the increase in pressure will find the next weak spot. Get your insurers to look at moling a new main and going into the house as near to the internal...

They won't cover the repair of the pipe. Which is usually the cheapest part of the job! It's standard policy with insurers.

https://www.wolseley.co.uk/product/plasson-7438-side-outlet-saddle-50-x-1-pp06578-44/?srsltid=AfmBOooCzyFjuVyvXtHeefRJRahEpCA2-Acz10IDd945C_v-si0X-XaT

I could probably fix that without you needing to make a hatch! I'd certainly try first. :)

Get a 25mm mdpe elbow. A reducing set to replace the 25mm collet and O ring in that elbow. Stick a bit of 15mm copper into it. Put in a lever valve (making sure you'll be able to operate it when it's below/inside the Kitchen unit when it's fitted) and then onto the 15mm house supply you have there.

Are you sure it's not condensation on the pipe? I'd rather have soldered joints on anything before the internal stopcock and defo no Ballofix. Change the stopcock to a lever valve.

Of course. Off peak demand.

If a genuine post then yeah... Where's the fookin photo?

"NoBlows" :)

Tune out my friend. One man's problem is another man's "kerfuffle" which is a great word but outdated x But I like the avoid Bournemouth bit! X

When I say meter... I mean "their kit"! With that mains burst photo you posted, all sorts of debris would have got shoved downstream and likely fouled up loads of filters/NRVs at the meters.

FFS! It was the suppliers meter end of. And then they send a femgineer who's sole purpose is to prove she's got bigger Bollöx than a man. Equality my arse!

If its from their stopcock then its their responsibility.

https://bearing-king.co.uk/products/loctite-55-pipe-thread-sealing-cord-immediate-full-pressure-sealing-50m?variant=40921584042074&country=GB&currency=GBP&utm_medium=product_sync&utm_source=google&utm_content=sag_organic&utm_campaign=sag_organic&gad_source=4&gad_campaignid=21053578467&gbraid=0AAA...

Wot e said ^^^^

Do. You have an outside tap?

These taps mix in the spout. Or at the end of it to be specific.

If I was doing it I'd print it horizontal. In sections with a scarf joint if necessary.

Could aways bury a rod in it ;)