Search results

Yes 3/4 gauge. This taps feed from 22mm so maybe a higher size

Thanks so no way of getting pressure test gauge on?

I'm trying to put my pressure gauge on this 22mm outside tap. The thread won't take 3/4 or an inch fitting

They were excellent. Thank you

Ah I get you put the bolt and nut in, in one go after the pan is in place. These fixings are usually ok then? I did think of throwing and using screws

Is like a bolt not much thread above so would have to get the height close to band on for the bolt to tighten

https://www.bes.co.uk/single-socket-bend-soil-vent-elbow-110mm-x-135-16120/ Like two of those put together. Does anyone no what size offset it makes

Think there official called single ended 45 socket bends

110 mm. Just 2 polypipe push fit single ended 45s

Thanks for all the advice. This is the basin

Thanks I don't have two fittings to push together sadly

Does anyone know roughly the pipe centre to centre measurement if you push 2 single ended 110mm 45s together. What size offset does it create.

.

Thanks I think there solid 6 inch breeze blocks

Thanks for finding that

Thanks just never fit one that heavy without a pedestal. It would be on a breeze block wall

I have some wastes.to run. I am doing 110mm in pushfit. And the 32mm and 40mm in solvent. What is best to connect to a boss/ the boss eye of a 110mm branch. Are the rubber ada

Thanks. I am wanting to go in to the eye of that in a horizontal water pipe run. With the 32mm pipe going in to it from above. Have always used the rubber connectors before but and thinking of going solvent

I want to boss into to the eye of a 110mm branch. If I use solvent am I best of with a solvent boss adapter to 40mm or can you still use the rubber ones? Thanks

I know have just swapped stuff before when trying to diagnose water hammer and then the noise has carried on