Search results

Yeah, I was planning on it. Thank you for everything, I really appreciate it. I’ll attempt it later today!

Thank you! So confirming that removing all thermostat wires in the PCB for STAT 1 and STAT 2, and bridging (linking) STAT 1 L>N/O and STAT 2 L>N/O will work? Then do the above diagram on the programmer end. Right?

I know I’m going to be a pain. Is there any chance you could draw it out for me? I’m still not sure what you mean by Wago to the dual channel etc. So the removing all thermostat wires in the PCB for STAT 1 and STAT 2, and bridging STAT 1 L>N/O and STAT 2 L>N/O will work? I think I do know...

Thanks again for the information. I am wanting to replace the programmer and have the receivers there in place of the programmer, instead of placing them in the water tank cupboard. Based of your information could you confirm if this is right? If I were to do the programmer side, I wouldn’t...

That’s amazing, one thing I have to mention. I have the wiring box upstairs on my water tank, and my programmer is downstairs under my boiler. Now if I were to follow your diagram, how do I get the black from STAT1 down to CH1(HO). The only connection I have going down to the programmer are...

Right, with that being said. What’s the best way to remove the old thermostats, and have Hive work? Do I need to bridge anything like CBW said above? Or removing thermostats from PCB do the trick?

Yeah, I’ve just noticed that. Do you think it’s getting power from the programmers end? It’s the only end where there is power… does that change things?

So are you saying, remove the two existing thermostats on STAT1 (L,N,N/O) and STAT2 (L,N,N/O) from the image attached. Then place a wire in STAT1 from L to N/O and the same for STAT2? That way when connecting HIVE receivers to the programmer it’ll work? I had removed fuse from boiler switch...

Here is the best thing I could find, ESI don’t make it easy for me to find it!

What do you mean by, link the wires up. The receivers will have, L,N and corresponding HW, CH1 or CH2. I’m more stuck on the wiring centre, I’m wanting to remove the wired thermostats, but unsure where I need to bridge if I take them out? Because if i dont won’t the call for heat not go to...

Hi! I’m looking on getting HIVE installed in my new build home. I’ve bought 2 Hive thermostats, one dual channel and one single channel. I have 2 zones, up and down stairs with a hot water tank. Currently I have ESI wired thermostats but want to remove these completely and rely solely on the...