Search results

Ok....thanks...

Recently my external gas meter had a slight leak.The gas company fitted a new meter.No problem...I have just moved into my present house.I could not help noticing that the gas supply,from meter to boiler,runs through house & is done in copper tubing.....Is this ok...? I just thought it should be...

Thanks...I've checked the w.site....Shall have to remove pcb & check identity.Almost certain of the board I need...Are these pcb's unreliable ?.My washer is only just out of warranty.

Latest......I've checked the pressure switch.Clicking in & out ok...Have switched on again & now have all the led's flickering again..If I need a new processor & shall bin the ficker...

Thanks for the above info....On powering up washer this morning,I have led's 1& 4 flashing(timer delay & extra rince).........Is this an eprom error ?

I've checked the plugs & connectors on to the boards & all looks ok...The led's i have got flashing are the green leds + red lock at top horizontally.And the spin/9h green led....at the lower vertical stack..The wif just informs me that it does this when she goes to use it,but it always clears...

Not sure what it's telling me if anything at all.But on initial power up at socket,all of the led's are flashing very fast.Not sure if this is an error message....Anyone help please..John.

Have compared the two wiring plans,appears that the brown core is not used on the Y plan.But on the C plan it's shown as the sync motor feed..?

Original(Honeywell) is a 3-port valve.So is pumped on both HW& CH..Sorry if I misled you..

Right...The one that is on is a Honeywell V4073A10952..Diverter Valve..the replacement I have is an Ikon type MA1 mid position actuator valve..Thanks John.

Hello guys..I'm a quallified sparky,but have limited knowledge,with wiring identity with heating controls..Here is my problem..I have a six wire diverter valve on my system,thinks its on a "C" type installation.The valve is sticking on the hot water position,when I flick the sync motor,it...