Search results

Hello I have a double socket with two cables going in, I am not 100% sure if it is a spur off a spur or I could have hit the ring If I'm lucky. I did not have a continuity tester with me to test. Anyway for the sake of this lets assume its a spur off a spur my worst case scenario. What I...

A quick question. Just trying to figure out the best way to fit an external pressure gauge to the flow just like below: I'm going to be cold flushing the central heating but no boiler is attached just yet so I want to keep an eye on the pressure. Many thanks.

Hello, I am getting a boiler fitted and got some questions. 1. The condense connection is a bit difficult due to the position of the boiler, the only option seems to be a condense pump. I will run most of the condense inside the house, will this all have to be in 21.5mm overflow until I...

I'm sure this pops up every now and again but we are at a point where its been fairly expensive! I remember when it was a £1 a metre. Just wondering where you guys are buying your copper and at what price? I got some to weigh in, old cylinder and some copper pipework so should fetch a good...

I'm getting an old boiler replaced and to save cost i am doing all the pipework up to the new boiler. So I have ripped out the old cylinder and tanks, will re-pipe new hot and cold and also pipe up Flow and return this will be all in place up to the new boiler position. All I ask for the RGI is...

Hello all! Heres a quick sketch of my current set up and I want to swap it for a combi. The hot water side I'm fine, the central heating is what is confusing me. What would be the best way to convert this ready for a combi? Many Thanks