Search results

I checked that and no, it does appear as though it is just that single socket on the floor below.

Thanks again for the advice given by 'almost all' on here :-) Thought you might like to know I've sorted it... Pretty much pulled almost every floor board up tracking the cables. Breaking the ring at every socket I came (come!) to. Found a random socket on the floor below that had been...

Many thanks for your English lesson... I was posting a topic on this forum in the hope of receiving useful and relevant advice regarding the issues I was having with my electrics, as opposed to my use of English! While I am grateful to you for highlighting my colloquial language choices, choices...

Thanks for the advise all.... I have been measuring at the CU itself, the circuit in question terminates to the MCB as a pair of cables (a single ring), measuring the L-E resistance on both of these showed the same resistance (as you'd expect) I left these separated and chose a socket which...

I'd ruled out neutral earth as a fault as all of the other circuits are still live and not causing a trip, the neutral and earth on the 'faulty' circuit are also still connected, it's when the breaker is switch on that the main RCD for that side of the CU trips. I thought that the readings...

Hi, Just come back from holiday, before I go I like to turn off the non essential circuits. When I come to put them back on again the main RCD trips when I turn on the circuit for the 1st floor sockets. I did the usual thing of removing all the items plugged in to that circuit, but the RCD...

I've got the manual (just cant seem to see the section)

Whats the procedure to reset it back to factory settings?

That's what I thought but have run out of ideas - everything 'looks' fine. been through all the settings I can think of too, unless you know of any i should double check - there are a lot on the Gardtec...

Hi, Thanks for the reply. There is no button, its a mag switch on the exit/entry door. When the door is closed the tone changes to continuos tone so I know that is okay. I thought it looked like the exit time had changed also, but I looked (have the engineer code) and its set for 3...

I have the 593 and it has just started not setting. When exiting the continuous tone is heard (after the exit is closed) but it just stays continuos tone, does not stop and set.... Display shows "exit now". When the exit is triggered it starts to beep again, and when secured, continuos tome...