Search results

Going to use some flex cord grips

I've got a 20a 4 way junction box and some 2 core flex so now I just need to wire it up I'm not too bothered about complexity I just want to make sure it's right and safe

Going to use a 20a 4 terminal junction box what size wire do you suggest I use?

The junction box will remain accessible and doesn't need to be too small

I will most likely be using BC lamp holders http://www.screwfix.com/p/british-general-cordgrip-lamp-holder-bc-white/48002 Running three wires (one from each holder) to a piece of wood where I then want to run it to the ceiling rose via a single cable.

Thanks for all the replies what I need to do is take three cables down to one to run up to the ceiling rose if that makes thing any clearer

Hi I'm making a light fitting that requires 3 bulbs wiring together to then run to a ceiling rose from a single wire. Any help on how to achieve this would be greatly appreciated thanks.

To make this work is it as simple as wiring a bulb a battery and a switch together or am I missing something?

do you think this would be worth giving a go?

Just found this http://www.maplin.co.uk/p/verbatim-1w-80-lumen-led-g4-capsule-a00nj# if I ran it with a 5ah 12v battery that would give a decent life span?

My initial idea was to use a 1.5v bulb and use a refective case as these bulbs are only 0.3w and have 200ma draw but not sure how bright it would be. I would use maybe 3 D battery's to give a decent life span.

I was hoping to use maybe 3 or 4 D battery's

I'm guessing they will be but website doesn't say

Found some 1.5w bulbs would that be any better?

How many hours of light would I be able to get from one of these?

Need some advice with a problem I'm facing I'm trying to put a light into a coffee table so ideally I need it to be battery powered as the table will be placed into the middle of the room I would like a 10w cabinet light in it but can't seem to work out how to get a decent enough bulb to run...

Looks like what I'm after thanks for the help

Would anybody be able to tell me what this bracket is called? It's for fixing a glass table top to a wooden Base any help greatly appreciated.

Found this picture on the internet of what i believe is a 1.9D and this does have a MAF but when i look at my engine it doesnt atleast certainly not in the same place. Ignore the red circle that was already on the picture i know thats the egr.

Revs jump for a couple seconds after startup (seems to be worse the colder it is) but the engine shakes to the point were you can feel it throughout the van like theres too much movement from the engine but this settles down the warmer the engine gets and doesnt do it at all when the engine is...