Search results

Hello, The washer (ZWF 1421W 3 yrs old) made some horrendous noises last night during it's final spin. The door seal was half-way down the door window, on further inspection the counterweight has eaten it's way through the plastic outer tub and dropped off it's mounts. I've taken the top off...

i removed the switch from the boiler before i tested it. power wasn't getting to the boiler, cleaned the power switch and everything now fine. bbb

Bleeding rads today, pressure dropped below 0.5 bar and triggered F05 fault. Located overheat thermostat but button not obvious if it was switching or not, no click, nothing didnt feel like it was moving. rigged a test lamp as no voltmeter, removed switch, lamp lights across the terminals but...

on taking the thermostat off the wall to ge at the wires it was obvious what the problem was. THe builder had wired the input of the heater element to the input on the therm but had wired the output to the live of the power supply. swapped the wires over and we have heat. thanks bbb

readings (forgive the possibly idiocy of meter reading confusion) sensor probe 20.6 ohms @ 200K heating element 0.344 ohms @ 2k (pos / neg) how would i check for earth continuity on the heater element?

it has been on for a good few hours, still showing 12 deg for the floor temp though it shows that it is running 'comfort' program 24 deg. Floor is stone cold though. will disconnect and check ohms, though i suspect the worst :cry: hope it is just a dodgy thermostat. How would I check the...

would i need to take the wires fully out of the thermostat to check resistance or can i leave connected up?

Hello, Had underfloor heating (electric) installed in our bathroom, downstairs concrete floor a fortnight ago. Used matting and thermostathttp://www.screwfix.com/prods/39460/Heating-Cooling/Electric-U-floor-Heating/Klima-FHT-Control-Digital-Room-Thermostat# from screwfix. Mat and control...

i wont be putting heating elements under the bath, only on open flooring. Fibreglass it is. THanks bbb

Hello, Re-doing our bathroom which is downstairs, single story and with a concrete floor. As it is baltic in there I am putting in heated flooring with Klima insulting boards underneath. The bath will be boxed in so I was wondering whether it is worth putting something underneath it...

no i will do it again. need to know as electric shower needs 1.5bar min.

2.2Bar

bought a pressure tester from screwfix, will give it a try tomorrow.

cheers, how would I find it? thanks

Hello Newbie here, I am fitting a new electric shower in our bathroom and it specifies a min mains pressure of 1.5bar. The combi boiler we have normally reads 1.5bar but can get up to 1.9bar with the filler tap opened. Does this mean that mains pressure is around 1.9bar or that the...