Search results

Also check cable size. 10.5 kw should be 10.0mm cable

Should be fine

. Although soon to be qualified Gas Fitter..... God help Coventry :roll:

A wiring fault somewhere?

IMHO, best left to someone who knows what they are about. I am not saying that you are not. IF it is the PCB, then eventaking one from another boiler, it might blow the other board. Maybe the board has gone due to another component failure.

Vivaro/trafic/primastar for me

To the OP The glendevon is one of the pricier kitchens, that Howdens do. Also you have a few decor panels and curved units...they jack the price up on any kitchen from any supplier. Personally find howdens kitchens to be one of the best out there. Fitted around 60 of them to date, so have...

OP Number 1 on your list is not even a gas issue, and have you have rightly stated, it is a GAS safety record.

I have had this on a few of these broag boilers. Was the link wire removed from the control board?

As already stated could be the diaphragm or the microswitch.

If you do take it out watch out for that pcb, with drops of water.Plenty of towels a t the ready

Ok Then As you have a 30kw at the moment, and realise its capabilities, then go for A vaillant 831. Good boilers. Personally the exclusive is not worth the extra cash.

More important than the brand of boiler, is the quality of install. I have seen a few dirt cheap aristons installed that have been really well installed, and many wb or vaillants that have been installed terribly. What are your incoming cold main flow rates? IMHO, a 32 kw combi will not be...

160mm is more than enough gap, to erect a sort of false wall in which the pipes can be run. 2x2x should be adequate, and allow enough room for plasterboard/aquapanel and tiles.

Nothing wrong with acrylic baths. Just make sure you get one of a decent thickness.

Maybe some pictures will help.... If it is an old heat only boiler, then the hot water cylinder could be gravity fed, on the primary side, therefore, if you were to change just the boiler then you would need to make the system fully pumped. Control wise, have you got a stat on the hot...