Search results

Tony When would be a good time / day to give you a ring? John.

Well 24ish hours later and it is still working, thanks to Tony's advice. Do you think it would be advisable to get someone in to check the gas valve settings are ok? also will we have been using too much gas by it not been setup properly in the first place? John

When the boiler was installed about 4 years ago, the CORGI guy could not get it to run, it would run for a few seconds and the switch off. He was on for hours and he did remove the PCB and then put it back, he failed to spot the flow sensor for the hot water was not attached properly. I "had a...

Tony I removed the wire and tested as before and the flame size was the same.... I followed the wires back to the PCB and found that the plug was not on properly, it was sitting at an angle. I have pushed it back on and retested. I now can see a difference in the flame size when on low flow...

It does light promptly across the burner in both directions Burner on minimum? I ran the hot water with just enough flow to fire up the boiler and it lights (with the same size flame as when on full flow or when the heating is on) the boiler runs then stops for a few seconds then fires up...

Tony thanks for taking the time to reply. Not sure how to test the min and max gas valve settings but the lockout did not come on. John

I have changed the temp probe and the boiler ran great for about four hours, I looked at the boiler and the light was flashing rapidly again and only the fan was running. Flicked the dip switch to get the fault code and now it is showing the left and right light are flashing together and the...

Thanks Tony you are a star. I will order a replacement asap and post back with the results. John.

Thanks Tony I've had the heating on all day today just waiting for the fault to happen, no luck yet..... John oo oo oo It's just done it..... The middle and right hand lights are flashing... Faulty NTC Sensor?

We always turn the heating on from the control knob on the front of the boiler, it always starts within a few seconds and the radiators heat up etc..... Some time later we notice it is getting cold and when I look at the boiler it is sitting there with the fan blowing and the lamp flashing...