Search results

hi yes if their short it wont be easy to get them tight fitting you could always take all the spindles out and fit a rip of 3mm ply in the groove gluing and pinning it and then fit your spindles back in with plenty glue around filletes ,you would probably have to thin the fillet down on the...

£40 to fit an internal door ? wheres your area im loading my van and heading down there haha i must still be at 1980 prices mind you if the door is in an old house and frames are not to square can take good bit longer than you think . i fitted 5 on sunday in just over 4 hours ,mind you the...

i would be careful about gluing them down as with change of temp and moisture the boards tend to expand and contract , which is why the click boards are so popular , if you glue them and there is any movement the glue will prevent the boards from going back .into its origional position and you...

hi there yes your right taking fillete out and fitting new ones in tight with plenty of pva glue will sturdy it up .if rails are loose you might find under the handrail after youve taken the fillet out there should be small bolts underneath to tighten handrail . but watch you dont over tighten...

theres 3 wires in thermostat so will i divid them up on the block and try switching central heating on programmer

thanks londonboy that was a really quick reply i will try it to see cheers alistair

hi there just a couple of days ago i noticed my radiator hadnt heated up in the morning .after a bit of snooping about i think ive come to the conclution its either my diverter valve or thermostat when i turn on programmer for hot water the boiler fires up but when i do it for c/h it...