Search results

  1. K

    Turf - and a bit of wetness

    If you really want to put a rotovate over the ground then go for it. It is not needed as you only need to "open" the ground if you are using seed, even then just scratching the surface is fine. If you do rotovate the ground up you will need to roll the ground again as just standing on some...
  2. K

    Hotpoint Washer/Dryer

    The code that comes up is F-04 and the drum doesn't try to rotate at all. It is still trying to fill
  3. K

    Hotpoint Washer/Dryer

    I have a Hotpoint WD860. It starts to fill for about 10 - 15 seconds then beeps and displays END and then. flashes F-04. I have replaced the pressure switch and the clear tube from the pressure switch down to the filter is ok. I have also cleaned out the filter. The problem is it is still doing...
  4. K

    How to get garden looking healthy (With Pics)

    What you could do to start with is give it a good tight cut, grass is tuff stuff so will take almost anything. What type of mower do you have? Get a metal leak rake, a good quality one as you will break a cheap one, and rake the whole lawn heavily so to scratch out that thatch that will be...
  5. K

    Turf question

    Spray the area with Round-up, as this herbicide is a good safe broad spectrum one. Leveling it with a good grade topsoil that you should get from a landscape supply yard, but do buy quality. I would not worry about putting down a feed before you lay turf as the turf itself will be well feed, I...
  6. K

    Turf - and a bit of wetness

    Dont bother turning the soil over as you are just wasting time. If you wish to get air into the ground just use a garden fork. Dont worry about the water lying on the ground its not a problem. to get the bumps out just get in some quality soils and spread it around with a rake to make it nice...
Back
Top