Search results

I need to replace a shower waste which has been solvent welded to the main pipework run. The main pipework is all boxed in: I have a short section of unboxed pipework that is all solvent welded. The only section of this unboxed pipework that is a remotely standard size is the exterior of a...

I have an Intergas HRE36/30 set up a a combi. Its coming up to 10yrs old. I have the Intergas outdoor temp sensor/weather compensation (WC) and have just upgraded my controls to Tado, connected to the boiler via Opentherm (OT). Original controls were actually OT too (Rhemea). It has come to...

Have an 18month old indesit gas cooker (ID60G2) The two ovens seem to give very different temperatures; at gas mark 4 (so 175degC ish) one is reading 160degC and the other approaching 195degC! Can the cut-off point of the thermostat typically be adjusted, so that gas 4 is gas 4 (i.e.175-ish)...

Hi, hope someone out there can help. Our 8 year old Intergas HRE, serviced annually has started to deliver luke warm (30-degree-ish max) water on DHW. I am located in a hard water area, south Bristol. From what I can tell.. Flow switch works (you can hear the 'click' when opening a tap...

Hi, The kitchen in my timber-framed house will be gutted..out comes plasterboard & insulation, and in goes new. Essentially all walls are constructed as per a partition (75mm deep studwork). Consumer unit is modern MCB type, with RCD protecting lighting (but not sockets – just on the...