Search results

hi,give it a try and see.it worked for me and a few others. you could remove the cb and repair but its a bit of a pain on this model,and whilst it is out you may aswell replace it for a new one. a piece of wood is free :lol: :lol: 8)

hi well if its like mine and the 3 others that ive repaired it can be wedged by a strategicly placed piece of wood.lol :lol: the worcester boys should have put a new board on it though,and they are guaranteed to fix it,play hell with them that its still not right,dont pay again for them to...

because its lost pressure for a reason,normally a split in the diaphram. its a sealed unit so pressure shouldnt be lost unless a fault.

new expansion vessel required. seen these rise very slowly on ch mode.on hw mode the high temp of the water shoots the gauge past 3bar.

hi there, if your pump and fan are running and the main burner is ignited but the sparking keeps going then its a flame rectification issue.theres 2 probes(sparkers)they ignite the burner on low gas rate,there is also another probe thats at the back of the gas burner im sure,a flame sensor.when...

there is a fault with this model that requires the circuit board to be replaced or it can be wedged in a certain spot to make the boiler work perfectly for another few years,and its free. :wink: i wedged mine with a piece of wood :lol: (yes i am gas safe reg'd!!!) the boards must break...