Search results

Hi again Rocks1, Found it and repaired it with a piece of narrow watering tube that I slipped into each end of the now-shorter (thanks to the mice) rubber hose. The wm is happily trundling away and all thanks to you. Do you wish to make any charge for your advice? If so, let me have your...

Thanks, I'll do that and see. JB

Thanks for that. One more thing - I tried to repair the pipe with some tape and it still did not work. I then noticed that the pipe seems to have a T-section. Is that correct. Does it run from the top electronic pressure unit (a cylindrical brick-coloured thing) then down to the RHS middle of...

Hi Rocks1 You are a clever thing! You were quite right - it was the tube. The mice had been in the machine and had eaten part of the rubber pipe along with stored some acorns in the top... I assume that I could make up a bit of similar pipe that would do the job, or would I need to buy...

Thanks for that. I will go and see if I can sort it. JB

Thanks Rocks1 You say that I need to check if the pressure tube has come off or if there is a blocked pressure chamber, then blow through the pipe on the inside of the mc. I have been searching the internet for a diagram of the machine to show where the above tube/chamber are and haven't...

Hi, I have a similar problem with a 3-year old machine. It has not been used more than 20 times during this period since it has been in storage and is now out in Spain with us. The machine will fill with water (much higher than it normally does) then immediately drain. The drum will...