Search results

Many thanks I'll try this out and let you know what happens. One final point I have two toilets which do not have a ball float in them, the water feed is slower and the over flow goes into the pan rather than down an over pipe plumber out through the wall. It seems I need to have ball floats...

Yellow when I set the system to pos+ head and green when I set it to neg- head. There are three Red LED's the only one that comes on in the final one which is due to the heat in the hot water side of the pump being raised above the shut down temp due to the water being churned in the pump...

Thanks for the idea. I've managed to move this on a little today and changed the pipe work to ensure the flow to the pump is a little more direct. The cold is direct from the storage tank in the loft there are two large tanks which feed into a 28mm pipe. I have taken this to the pump and then...

I do not have a flow rate sensor on the system. My thoughts are that I have the pump connected to the cold water tank in the loft via 22mm, I believe this should be 28mm and reducing to 22mm close to the pump is this correct? The pump is getting warm/hot on the cold side of the twin...

How do you do this? I've set the led's to Positive and also tried negative is this what you mean? Many thanks it sounds as if this could help.

I've tried in positive and negative modes. I can't find any minor leaks or dripping taps. Your note of caution is well received, i'm a little concerned where all this pumped water is going.

Sorry my mistake the hot watre tank. cheers.

Hi there I hope some one can help a newbe. I've just spent the day installing my new Salamander pump. Pipe work went well made sure the pump which is for the whole house takes the feed from the header tank for cold and the boiler tank for hot. Went to switch it on and every thing went well...

The loo / cistern is clear, so I think I'll go for an external vent. Would anyone know if there is any information outlining the best way to go through a tile roof? Cheers again for any advice.

Yes, I've checked behind the toilet the connections are all sealed correctly and no smells from this area. Once I lift the seat the smell is increased significantly. Thanks for the rapid reply.

Hi there, I have just completed a major redesign to my ensuite. The issue I have now is I'm getting smells coming from the toilet actually from the bowl. The water trap is full. The toilet goes directly into the soil pipe and the soil pipe has an AAV fitted. I'm wondering if I should simply...