Search results

error

Hi I recently had a Duel flush toilet installed works great , but at random usually when left for some time a thin trickle starts running down the pan and after a length of time after trickle starts the toilet starts trying to fill and making a hiss Noise , Its never stops trying to fill (very...

delete wrong place

posted in wrong place delete

The wall is dry now its only wet when its been raining it dries a little slower as there is a small canopy above stopping sunlight. Just checked today and it is indeed dry the moss is very slight and drops off easily.

Hi I have noticed a small area of external side wall on my small porch about 2m long has a couple of green lines of very thin of moss along the side. Its easily rubbed off there is no evidence of damp, the wall is only a couple of years old and in good condition but I have not noticed it...

Sorted

The ground is Resin bound Suds compliant and water seeps straight through it also the same water drops on it anyway in a diff place. The flat canopy is very small just covers a little more than the door. Is there alternate answer to build up the front edge on top where it drains off with...

Please delete this thread I have the answer

Can you explain The flow would be rare and just a tiny trickle just as it is now except not on my head while entering ? Any idvice would be great.

I will try tomorrow the real question is would i be ok to let the downpipe drain onto suds drive as canopy is tiny and very low flow or am i just creating issues.

Hi I have a felted flat small canopy above my front door its slightly bigger than the door width. When there is heavy rain the rain pools a bit on top but sometimes but rarely it drips slowly over the front edge. I was wondering if there is an easy solution for it , small bore drainage...

well its dark now will put off till monday thanks

there was non link on old one i tried linking new one no effect might try again as that seems logical would the old one be linked internally

red went to L1 yellow to L2 and black to common on one side of old switch opposite side red went to L1 blue to L2 on old switch no common The new switch seems to have these side by side instead of upside down (compared to each other) on old switch

must add 4 cables form both incommers red red blue yellow go to bottom of new swith black goes to common on top of one side of switch

Just decided to fit a new brass 2 switch light switch like for like with very old plastic one Swapped cables like for like but only one light now comes on Cable feeding has 3 cores black red earth other cable coming in has 4 red yellow blue earth I stress i have put them into same...