Search results

Hi I've just installed a floating engineered floor but there are gaps where I used too much glue in the the tongue and groove. Part of the floor is in a kitchen and I'm worried about water getting into the joints. Does anyone have a solution for filling the gaps? thanks

Hi I've almost completed laying down a tongue and groove floating floor and have realised that I have probably overdone it on the glue front; Instead of fitting snugly as I now realise they should, there is a gap of less than a milimetre. Tearing up all the boards is not an option so I was...

Hi I'm about to install some 6mm insulation and floorboards over a concrete floor. There are a very few high points in the concrete (20cms wide max) that need leveling down by a maximum of 1cm. What are the ideal tools and methods for doing this? Thanks in advance

I'm looking into laying floorboards in my lower ground floor flat where room height is a bit of an issue. At the moment it's a concrete floor. I was thinking of adding 12mm of celotex followed by 18mm tongue and groove chipboard and then 18mm wooden floorboards on top of that. My question is...