Search results

No burner does not come on once warm water used and leave tap on, it just stays on stand by. Unless I press menu and switch to comfort mode then burner kicks in.

Yes it's flow turbine I changed. It seems to send message as temp goes down to 40ish flame signal kicks in, and gets temp to 65-70 but have to turn tap off soon as water goes Luke warm and on again after about min and warm water comes again.

Hi first been waiting all day to figure out how to post thread lol kid done it in end. I have had couple of cowboy plumber who fixed a problem and on way out created another. All started with freezing sat morning no boiler, called recommended plumber who cleaned heat exchange with acid and low...

Same issue with mine, what did you do to fix?

Why is the standby not going to on demand and firing burner on?

Hi I don't get hot water on demand kicking in I've checked most wiring but all looks good? What other place do I need to look at, any advice will be appreciated as not had proper hot shower for a while.

I had ballooned up patches of plaster on section off wall where, on out side drain water pipe is from roof. so i knocked that whole section down and brick work is damp and theres roots spreading all over the brickwork. How do i resolve this problem?