Search results

Hi rocks1, yeah I think i'm going to send the pcb board back to be checked out, i'll let you know how I get on. Once again thanks for all your help, you've been very helpful. Cheers, ratattack.

Well this is the second pcb board that i've bought from an company who repair them (EMW). it's an exchange board, you know, you send them your broken board and they send you a repaired one. You don't suspect the motor then? It does look like it's brand new and it hasn't done much work it two...

Hi rocks1, i'm back. Removed earth wire on heater element and taped up wire, here's what happened. On a 1.23 min short wash with 1600 spin at 40deg. 1.23 machine fills twice using both inlet valves in turn and wash begins. At 59mins machine drains the hot water as the rinse phase starts...

Yes ok, I can do that. I'll get back to you tomorrow as i've now got to cook dinner :lol: It's 6pm here in blighty. Cheers mate and thanks again, Ratattack.

Yes I have an ohms meter but no megga.

Right, I see. Can you tell me how to check the heater then. thanks again rocks1.

Ok but I don't understand why it's a heater fault when I know the heater works. Does the heater work during a rinse only program then, I thought the machine only rinces with cold water.

Ok, here's what happens on rinse only program: 39mins machine starts and fills drum rotates. At 37mins machine fills again (larger amount). At 34mins machine drains with rotation. At 33mins machine starts to fast spin - two seconds later the motor gives a tiny hiccup and slows to a...

Hi, Just checked the machine, and yes it fills twice before the drum rotates so the inlet valve looks good.

Hi, got a bit more info. Have tried a hot wash program which worked ok until of it got to the first rinse and then 'hung'. but at least I know that the heater is working. I also tried the the drier program which was ok, fan and heating element operating correctly. I've checked the pressure...

Hello again Rocks1, thanks for your last post, but can you tell me the colour/position of the heater wires I need to check on the PCB. Also, my last post wasn't quite accurate. I have now discovered, after sitting infront of my machine, that it 'hangs' on the first rinse in the wash cycle and...

Hi rocks1, Do you ever get the feeling that some electromechanical objects seem to enjoy not working! Thanks BTW for the 22mm copper lever tip, I managed to get the belt back on whilst still retaining most of skin on my knuckles. So, I thought, box the machine up, bung it back in the hole and...

Hi Rocks1, Thank you so much for your help :D I have now refitted the control module and was looking forward to some clean washing when I ran into another small problem. I had removed the motor to have it checked for faults. After bolting it back in place I have discovered that the drive belt...

Hi all, Can anyone give me advice on the positions of the connections which apply to the control module of my wdd960? I managed to ping off one of the connectors whilst removing the old module before I had chance to mark it down on my diagram. the trouble is there seems to be two different...