Search results

Thanks for the effort, I've found the drivers for the modem and chipset, this evening. All I need now is to identify the USB device and find the correct driver for the graphics card; VIA VT8366/A, VT8367 Apollo KT266/KT333 128Mb DDR.TV OUT. Thanks for trying

Thanks to you both for the advice but I'm a little hesitant to d'load the GeForce drivers from the site that you suggested, I did visit the same site last night. The reason being is that their ID Number doesn't seem to correspond with card that's installed in the machine. e.g. my card is 4200...

I've Looked through all the postings sent by members of the group but I cannot find anything that relates to my problem. So hopefully someone can give me guidance. My friend's children have access to the family PC ad hoc and must have been visiting PS2 cheats sites, (nothing more sinister than...

If this comes about, expat's will be swimming across the 'herring pond' to escape the 'buddy can you spare a dime' experience. http://money.msn.co.uk/investing/Insight/SpecialFeatures/ActiveInvestor/dollarandshares/default.asp Don't rush into it, check it out

It would be unfair of me to name the person who was doing his best to help me. But he told that if I carried out a test the circuit board is faulty. By circuit board I take it he meant the Modulation board. Here's part of the massage; If you still get the low pressure neon on after this...

When your request for help goes into forgotten world of past pages without resolution. You know you've got a serious problem. Having carried out all the recommendations at a cost of; Modulation board £115.00+ vat = £135.12 Pressure switch £ 14.21+ vat = £ 16.70 Total cost £151.82 And...

A little bit of confusion Kev. I asked for help because the Low System Pressure LED was lit up and the boiler was dead. No Hot Water and no Central Heating when called for. When I cleared the scale out of the Water Pressure switch I got heat and H/W for a short period but the boiler died...

It is 1.0 Bar on the pressure gauge. Last night I topped it up to 1.5 Bar and by this morning it had crept up to 2.3 But I have since drained the sysem off and refilled.

Have I discovered a further problem. After disconnecting from elec and closing isolating valves, I removed the drain plug from the pump. The water drained off until an occasional drip, indicating the system was empty, so I loosened the pressure switch. The drip from the pump turned into a...

BDL Thanks for the prompt reply. I will do as you say and clean out any residue in the switch/manifold. I have checked the continuity of the switch with a digital multimeter (with the system pressurized and disconnected from the elec. supply) and I get a reading of 00.05 ohms, I don't know...

Well fella's my elation is short lived, the Low pressure LED is back on and I have no H/W or C.H. After I'd cleared the pressure switch and manifold of scale and re-fitted it, I tried the hot water and ran it for a short while, but I turned it off after a couple of seconds because I hadn't...

BDL & Weargas, I gotta tell you lads that your advice worked a treat and I'm extremely grateful. The Water pressure switch and the manifold was gunged up with scale so I cleared them out and *WOW* Hot Water! My wife reckons that the flow is much faster than before. Is that a good thing? Do...

Hi, I have a Puma 80e that has been giving me intermittent problems for some time. Here's a short history of my boiler problem. The system is about 8 years old and it has give me good service despite failing in the depths of winter. There's no evidence of Global warming in our house :wink...