Search results

I don't have trv on the rads downstairs, I did not fit this system so when I update I will take care of that but the take off wall and flush through I think is a good idea.

How can it be balance system when I said if I close all rads but warm one it still does not get hot for some time!

In my old house I had a combi boiler. I installed the whole central heating system and it always worked very well. All rads would get red hot within about 30-40 minutes. In my new house it is a conventional boiler warming 5 rads downstairs and 5 rads up. A couple downstairs especially, get warm...

Hi SD If I were to go GSM route, configuration seemed to be ringing ARC first.I can't remember what I did, I think just took out account number and centre number and it stopped doing this, am not with alarm or manual at moment. I just want to confirm it possible to text without calling out...

I have finished installing my G2 +44 alarm last week after ironing out the final problems. All works well but I would like it to text me when there was an alarm trigger. I have a Virgin phone line and a Virgin mobile.From what I have recently learnt the panel uses the tap protocol to send the...

ok thanks

Hi SD I reconfigured this morning and worked first time as I wanted it to and you said it would. I then checked the log and it did force omit. It went off the once in the study then not again, I walked into the hall and it triggered again. It's the first time I've used a forum but I'm...

Many thanks for that. I'll give it a go tomorrow. I don't think it would go down to well with neighbours now!

Yes that's correct. I tried setting it once with the key fob from in my study while I was entering this post. The PIR in that room which is the only one that would trigger is set as an intruder zone. For the test I set the bell time to 1 minute so the test would be quicker. I did the alarm cycle...

Hi I recently finished installing a G2 +44 system and all seems to work ok after ironing out most problems but when I go into menu 51.09 Zone Lockout the default is No lockout but I want it to lockout after about 3 zone alarms so I've tested it with 1 event but it continues to go off even...