Search results

If the machine waste is connected directly to the plumbing under the sink, it may be that the water draining from the sink is flowing back into the machine rather than going to the main drain. Unless the waste pipe to the main drain is blocked, this can be rectified by raising the height of the...

depending on your washing machine it will either skip the heat up part or just continue to boil if it just keeps boiling or skips the heat up part its the thermostat (if its on hot+cold water fill it wont mix the water correctly and will get too hot and shrink your clothes) one way to test it...

Often this is caused by wear of the drum bearings. If the drum bearings are worn there will often be a brown rusty stain under the machine towards the back and/or the drum will seem loose on its spindle. Getting the machine repaired before the bearings collapse is a good idea, since persistent...

if the fuse on the washing machine blows, or the household electricity cut out switches off the power when the machine is used, take it as a warning that there is a fault on the machine that requires expert attention. Avoid repeatedly changing the fuse as this can cause further damage to the...

This is a common problem that can be caused by many different faults. The least common of these is the failure of the timer itself, although this can happen and is usually expensive to replace. It is much more commonly caused by the failure of other components.

put them in the bottom of the dishwasher not the dispenser as we have had that problem before that should solve ya problem

well to be exact you don't need hot water fill but it does make the time to takes to wash shorter and saves on electricity as the washer doesn't need to heat the water :)