Search results

I know you can check if a business has a number but are you saying I can get a list of their engineers with numbers?

Not as far as I know.....just put in a new Combi.....connected gas, hot cold supply, flue etc....did a gas test and switched it on. The figure did include a bit for parts....maybe 40 quids worth at most though..... To be honest I'm more concerned about the principle.....if I'd wanted to do an...

I thought I had....the guy who came to quote was registered then he sent someone else who said he doesn't do gas work all the time....made me think. How much does it cost per year to keep up your gas safe registration as an individual?

Well he has been really difficult about notifying gas safe about the install. Made me think a bit as to why....... I know about the web site and the company has a number....it's the engineer that couldn't give me his own number. Smells a bit eh!? Jim

well I realised it would be dead easy for the person to work out I was talking about him...the chances are slim but I want to make sure the guy who runs the business notifies gas safe first.....he will probably put his own name on the install paperwork....then he has put it all in writing. That...

.....If you suspected someone was not gas safe registered...and you had already paid them?

Any suggestions as to the best way to block/cap an old drain where a toilet has been removed? It's in a ground floor bungalow where the room is no longer a bathroom. Floor has 4 inch hole leading to manhole outside via usual 4 inch pipe. Nothing else uses the pipe so my thoughts are to block...

Any suggestions as to the best way to block/cap an old drain where a toilet has been removed? It's in a ground floor bungalow where the room is no longer a bathroom. Floor has 4 inch hole leading to manhole outside via usual 4 inch pipe. Nothing else uses the pipe so my thoughts are to block...

Assume this apples to the rads...so if the total output of each set of 3 rads is less than 13kw I am ok with 15mm? And where the 2 sets of pipework go to/from the boiler (28kw) it's 22mm. thanks for your help.....Jim

Usually the flow/return from a combi boiler is 22mm then tends to go down to 15 the further you get away from it. Is there a rule for this....ie if there are less than 2/3 rads to feed you can use 15mm? I know it is ok for single rads...just wondered if you could go for more...

I'm sure this has been asked before but I have checked and can't find the answer elsewhere...... I am installing a Scantronic 9651 board and 420 PIRs. In the installation guide for the board it explains clearly how to wire the PIRs as FSL with EOL resistors so that you can tell which is the...

It would have to go round a 90 deg corner so would I need a proper manhole or just a chamber for rodding etc? Fall is ok.....20cm over 8m which I can get fairly easily.

thanks.....not too worried about the mess, but could do without future probs with damp.....! Awaiting visit from building control.

Hi - need some advice....I need to move a bathroom to a different location in a bungalow with a solid floor. The hot/cold can go up through the roof void and down stud walls but I can't decide what to do about the soil pipe. Option 1: Break/dig a trench in the floor approx 4m long and connect...