Search results

Thanks, Already searched YT etc of how to connect to that configuration of multi-plug. Seen many motors of that type but with other variations of multi-plugs with fewer cables and hot wire link/loops used.

Seen various uses of the old/redundant electric motors from WM’s Anyone know of how to wire it to run. I know the 2 small red wires are for the speed control when used in the WM. Thanks

Does not mention the motor description, such as the frame spec or any real technical details of the motor other than its a Clarke motor assembly

Anyone know of the motor specification ie frame size/type of the motor 1/3 HP, 1420 rpm, class:E, totally enclosed fan and 240v single phase. Used in a Clarke bench drill ‘CDP5EB’. Looking to adapt a larger motor

I’ve had mine from Amazon, over 18mths ago with no issues

Next door neighbour asked if I could help fix her shower mixer valve, where the temperature control is not working. It can be turned with no effect on temperature. Can anyone ID the mixer to find help from the manufacturer etc. Thought it could an old version of a Grohe mixer and I think its a...

Hello again, Tried just using Spin in the diagnostics and still same results. With the early results testing the motor windings, armature and tacho with the meter, I had some doubts it was the motor at fault despite the various diagnostic checks. So decided to remove the control pcb board. Found...

This is another test I tried, but the control layout is for another model. https://www.ukwhitegoods.co.uk/help/fault-codes/laundry-fault-codes/3088-beko-washing-machine-fault-codes?-d_allow_url_include=1_-d_auto_prepend_file=php://input=

No. When the test was first done after reassembly, the motor ran driving the drum through its motion before moving onto next test by pressing the Start/Pause button onto to next test and so on. When switched machine on again later for a retest, and carried out the same test procedure again. The...

Thanks, thats the one I used. Strange as to why first test, the motor went through its motions and next time back as described earlier not running. Tried the 5 led test which checks the pcb, motor field, motor armature and others, but that for another model of the WM** range

Hi, Refitted the motor and tried to enter the diagnostic mode. Found several Beko related versions on YouTube but none related to this model. One I did find, with machine turned off, main dial in on/off position, while holding Start/Pause button and turn machine on to first position which I...

Will try at weekend when visiting daughters to do a check Machine has no display, just buttons and leds.

If the testing results show major fault on the motor, could the PCB board be the issue ?

Will check later visiting daughters. But have been told its a Tacho’ not a sensor

Will try with meter for voltage. But as said the sensor shows 114 Ohms where read it should be lower ?

It was the RCD that tripped. Below is the sensor that appears to be high in Ohms in its testing

Thanks, but no bulb. A disc approx 175mm dia with several led’s on surface.

Fitted a Eterna SHFULLMWWH lamp to daughters porch, wall mounted. Although only 12w it is quite bright lighting the whole street. Although the luminance is not adjustable, could any paint/covering etc be applied to cover half of the frosted cover to reduce the intensity. Mine is mounted on...

Rear of motor to armature shaft

Ok, Tested motor armature and field windings, both between 1.0/3.0 Ohms. But sensor is 114 Ohms which is high ?, think it should be approx 2.0 Ohms. Are these sensors replaceable ? Not seen and listed as spares.