Search results

Any idea why the low voltage then?

One of these. Why the low voltage?

I am trying to replace the hanging bulb light in my back room with a low power square ceiling light and when I have taken the ceiling rose off I have see this which seems very odd. There are 4 red wires going into the centre and three black wires going into the bottom connector together with the...

Is there any way to reattach a section to the wall without taking the whole section down? I don't know why but the builder used 24" wide sections with what looks like 50mm deep blue insulation on the back. The top section has been pulled away from the wall and is no longer firmly attached. I...

Not sure I understand what you mean. "Fix through a hollow part"?

My other problem then is it appears that the plasterboard/insulation has pulled away a bit from the wall. Do I need to cut the lot away remove the insulation from the brickwork and patch another piece in, or is there a way to re attach the current plasterboard?

I have had some shelves come down from a plasterboard wall. I had used some things designed for plasterboard but I guess they/the wall wasn't strong enough. I can repair that ok but if I. To put the shelves back up I will need to find the studs to screw into. I have been using a really strong...

I have one of the Sheppach Log Splitters and the return carriage (red) is bent and I need to take it off to bend it back. But to do so I need to remove the return springs Yellow. Any idea how to do this safely and tips to putting them back on?

Installing the pump so that the direction is the same as the old pump means that the label on the front is upside down. Can this pump be installed with the writing upside down or do I have to take the shell off and turn it round?

The room thermostat, the boiler is set to about 70 degrees

It is not now giving me error codes but is just short cycling, turns on, fires up, water gets to temp set on boiler and it turns itself off, cools and repeats. Cycle is about 1 min in length. The radiators are warm at best. I can hear and feel the pump is at least doing something, it is not...

Check the pump?

The boiler hasn't come up with any error messages for the last 12 hours or so, but it isn't working correctly. The boiler comes on, the water starts to heat, quickly rises to temperature set for rads then turns itself off. Cools down and repeats. The cycle lasts about 1 min. Short Cycling? I...

NP Don't know. It was saying f24 but then went onto f23 which I think indicates a blockage?

Not at all, I cannot see anything from Agile about a bypass valve being probable or even possible cause.

Where is Agile's advice on this, I cannot see it in this thread.

Will give it a go. It is now showing F23, dislodged some gunk when cleaning the mag trap?

HI, My radiators stopped working yesterday. I can see on the boiler that it starts up, water temp rises to set temp and then shortly after it shuts down again. I can hear and feel the pump upstairs doing something but no heat goes to the radiators. This morning the boiler showed F24, pump...

Does anyone have any ideas on how to remove the pump on one of these? I cannot see how to remove the base to gain access, any ideas. (Someone decided to wash a cushion that came apart in the washer and it now needs a clean out, E18. I cannot open the filter cap. I need to get into clean...

My Washing machine works fine as a washer but recently refused to start the drying cycle. I have replaced the machine and this one is showing low water pressure, could this have been what stopped the dryer working?