Search results

As the windows came from a small fitter it was one style of window or nothing, the windows fitted don't have the trickle vents in. Think i might just pull the house down and start again, get myself a ground source heat put and heat recovery system which might help with the ventilation...

Morning, One of my pet hates is window condensation on a morning. Last year we had our old uPVC windows replaced with A rated windows which I hoped would help solve the problem. This hasn't been the case, speaking with the window fitter they've suggested it now might be even slightly...

Hi Andy, If is just to pump the hot water to the 2 bathroom taps and kitchen hot water tap another it's not needed for this one. Thanks.

We have recently had a new bathroom fitted, however the sink and bath taps fitted seemed to have reduced the flow and pressure from our gravity fed hot water system. I've been looking at different solutions to increase the pressure including replacing the vented cylinder with an un-vented...

Thanks Tony, the new taps are all low pressure ones.

Thanks Madrab, that's where I found them as well. Just was hoping to find them somewhere local. Looks like i'll need to bite the bullet and get them posted out. With regards the other valve I need to get down to .5 at the outlet to be within the tolerance level of the taps. Thanks again.

I'm after a Pressure Reducing Valve 15mm compression with Gauge made by Intatec but can't find anywhere that stock it. Does anyone have any suggestions? PRV22331510 SPECIFICATION Adjustable pressure range: 0.5 - 6 bar Factory set pressure: 3 bar Max inlet pressure static: 16 bar...

I'm after a Pressure Reducing Valve 15mm compression with Gauge made by Intatec but can't find anywhere that stock it. Does anyone have any suggestions? PRV22331510 SPECIFICATION Adjustable pressure range: 0.5 - 6 bar Factory set pressure: 3 bar Max inlet pressure static: 16 bar...

Thanks mfarrow The cold is mains pressure and the hot is gravity fed. TBH i was thinking why i need the check valves because the bath taps which came out was a mixer tap which I believe was single flow and didn't have a valves fitted and we've had no issues with that for the past 4 years.

Thanks for your reply, It is gravity fed and only about 1.8 meters below the bottom of the header tank. TBH i was a little disappointed that no other options were given when I asked about the flow and time for the water to heat up especially as looking online I found 3 other solutions...

Hi, hoping someone might be able to offer some advice. We've just replaced out bathroom and have gone from 2 separate taps on the sink and 1 dual flow tap on the bath to a single flow mixer tap on both. The plumber has fitted a non-return valve on both the hot water supply to the sink and...