Search results

Fixed. The owi or water pressure sensor, was clogged up with grease. This is the black mesh object inside the tank in the bottom of the machine. The machine thought it was always filled with water. To remove it go in under the machine by taking the bottom plate off. The connector with 3 grey...

My machine did the same starts, pump runs, stays to beep and rinse light constant flashing with no code. Run diagnostic and it runs fine and ends with eco program flashing It turns out the water sensor (the black grill beside the ntc in the bottom of the tank inside the machine) was clogged...

As no-one appears to be assisting with fault finding on Whirlpool dishwashers anymore, here is a link I have found to Service Manuals for the dishwashers. Hope it helps you fault find. https://www.manualslib.com/brand/whirlpool/dishwasher.html

My turn for an Adg957 fault. Machine is 18 years old, no Led display. In the past I've changed the NTC sensor At the moment if I run it on any program, the pump runs and runs and after about 10 mins it starts to beep. The error code on the left most led (rinse) flashes twice a second so...

Friend has bought a new house, I went to change the Euro lock but discovered the spring bolt latch doesnt spring anymore, deadbolt works fine. The lock is stamped up as Yale but I cannot find a Yale lock that looks like it (its well over 10 years old). It has no hooks or rollers, it has...

Sorry, that should have been CAN'T understand discrepancy :) External gauge moves fine, I've depressurised and repressurised a few times. Reading a few other threads, yes, the expansion tank I will check the pressure on it (should be 1 Bar according to manual). Might strip the sensor off and...

Just bought a flat which has a Dimplex (now called Powerstream I believe) Ascari 12kW Electric boiler, it is controlled by a Danfoss unit and runs 5 rads and a towel rail as well as a loop to a mains pressure HW tank. As far as I can see, the controller is demanding heat from the boiler, the...