Search results

How do I adjust the CH Pressure in my CH Combi Boiler? Switched off it is barely touching 1bar on the gauge, but in full flow it is almost in the RED zone touching 2.5-3bar

How do you actually add inhibitor to the Central Heating System, my system is sealed I think, there is no water storage tank whatsover, it comes from the mains and then through a loop. (Baxi 100 Bahama).

I purchased, 15 - 1/2 flexible pipe, as you saidit is a compression fitting one end and 1/2 inch female screw thread the other, I thought this 1/2inch measurement referred to the dia of the fitting but I find it more like 3/4inch as you mentioned. The tap connector I bought seems to fit...

I am replacing a radiator in my room and want to draindown to solder on new piping, the problem is my combi boiler is in the basement of the house about one metre up on the wall, there is only one radiator in the basement at ground level and there doesnt seem to be a draincock on the piping at...

I recently purchased Toilet, Pan and Cistern (The manufacturer is Gala, A Spanich Company). After visiting B&Q Warehouse I thought I'd purchased the correct connector, wanting the braided bendy type but unfortunately the threaded end is too wide. The connection on my cistern is plastic...

Cheers Ant, Masona I had a plumber visit yesterday evening he made exactly the same suggestions he mentioned that the connection between the plastic and iron would need kind of rubber sleeves with fastening clips, he also mentioned cutting the pipe with an angle grinder, I cant see how this...

I want to add an extra plug socket in a room, I have read that the easiest way, is to add a cable to an existing socket on the circuit thus making it a spur, but how do I know the socket isnt already a spur? I have read that you cant have more than one spur on each socket, Is this fact? Thank...

I want to fit a toilet in the first floor utlilty room, the problem I have is that my soil pipe is cast iron and runs down the corner of the outside wall, it is about 3 inches from both walls. How do I connect plastic piping to the cast iron variety of the same diameter? Cheers to everyone...