Search results

A firmware upgrade has resolved this. Panel was previously 2.04 and is now 2.11. I believe the following issue from the release notes describes the bug: "When mixing wired and wireless expanders on the system, if the wired expander has an address that is higher than the preceding wireless...

Hi, Wintex 6.2 build 0.2. When the contact is opened/closed/tampered, the resistances shown in wintex correctly reflect the expected values, but the zone status continues to believe it's configured as NO/NC instead of EOL. I had a similar problem on a different expander which believed it...

Thanks guys, I think I realised this myself too at about the same time. I think the slightly abstract naming of things threw me. I just assumed that the speaker outputs were the internal equivalent of the external bell. I've wired the soundbomb up to the Bell+12 and Bell-nve and of course it...

In these screenshots both zones are configure identically as DP/EOL

Hi Everyone, I don't know if this is a firmware bug but I have no other explanation. Zone 1 on my 8XP expander is configured as DoublePole/EOL but is reporting status as if it were a NC/NO zone, i.e it reacts with active/secure on low and high resistance values instead of 2k2/4k7 resistance...

Hi Everyone, I'm completely puzzled. I've purchased a Secware sound bomb to use as an internal sounder with my Premier Elite 48. I've tried connecting it to the keypad speaker terminals as well as the control panel speaker terminals and in either case the output is barely louder than the...