Search results

That worked. :D

Hi how do I wire a Siemens RF controller to a baxi duotech 24 kW condensing boiler. Any help would be gratefull thanks.

It would be worse than Richard the third, sinks getting used for washing junkie methodone cups. Lol

I have a gurgling noise coming up my sink, when the macerator is activated in the other room. Three sinks are linked into the system , anti syphon traps are fitted to all the sinks, 1 macerator is fitted because there was no way of getting the waste away otherwise. It's pumped above ceiling...

Thanks 4 all your help, that done the trick. Cheers

Ok I'll give that a shot and I will get back to you guys. Thanks again

Diagram for cm900 as follows terminals N L L then. Terminals A B C. Worcester Bosch terminals are L N 230v out and LR with a rad pic on it. If I could just know what goes where thanks will

Ok so , I'll do it to the worcester instructions , and L1 on the receiver side does not get used ,instead i run a wire from l2 on the receiver side to LR on the boiler and link live to live out on the boiler then link live to common live on the receiver and neutral to neutral on the boiler, then...

Inside the honeywell rf receiver there are low voltage connections L1 and L2 it then goes to say that they should be connected to low voltage connections 1 and 2 inside the boiler. This i have done, it seems to work but the boiler still seems to be calling for heat when the programmer is...

Hi I'm wondering if anyone can tell me the correct wiring for a honeywell cm927 programmer. Going to a worcester Bosch greenstar 36 CDi compact. Have wired it already , but boiler can still be controlled by front panel and the temperature can be turned up and down by the controller. I have L1...