Search results

Yes thanks anyway secureiam

Yes, I notice that as well the bloke who fitted the alarm 29 years ago must change colour halfway through. yes, zone 2 is the landing PIR blue and yellow. But the good news is you were spot on there was a break in the yellow wire it was trapped between the roof joist and a supporting brick about...

Wired them together still no joy will check the run of wire in the garage some of it looks a bit ropey I will get back to when I've checked it. Thanks

OK tried wiring like said above but no joy when I try and set the alarm the zone 3 on the panel with the new PIR just stays lit and get a constant beeping. Lights on PIR all come on when walking past then go out. Do I need to do a factory reset???

I see thanks for your reply much appreciated

What are these jumpers for can't find any information about this

Thanks again sparkymarka

Thanks sparkymarka Does it matter which way blue and yellow go and do I leave all jumpers as they came as Thanks again

Thanks for your reply

Need to change a 29-year-old PIR in the garage been going off during the night. Got a Texecom premier elite dt afg-0001 to replace the old one need your expert advice on how to wire it. The old one has only 4 wires going into it black/red from aux in the panel and 2 blue/yellow tamp. The...

OK done what you said seems to work fine see how it goes thanks for your help.

The original alarm was done by IAAI Installer 29 years ago, have look in the PIRS and they have two tamp wires and pos /neg

this is the old bell box and panel

Hi will try that how would I go about wiring correctly? Thanks Ray

Bell box connections (A) red/white12v (B) Blue Bell (C)Black Tamp (D)Yellow 0v (S) Green STRB They are what I labelled from the old panel and replicated in the new one. could it be the yellow and black in the TEMP connectors in the panel need moving to 0v and tamp where I have the wire loop??

Hi, It's a Texecom Odyssey1E and a Veritas 8 panel both brand new. Bell box connections (A) red/white12v (B) Blue Bell (C)Black Tamp (D)Yellow 0v (S) Green STRB Thanks Ray

OK, guys alarm working good but reading the installation manual it states they should be no link in (D)0v and (C)tamp no other wires in these terminals I put a link in when installing so on reading that it should be removed I did so. The problem soon as I removed it siren went off even when...

Thank you all working now

OK got as far as turning the zone of in prog 51 then pressed part, alarm set PIR was off on landing opened front door alarm went off no sound from bell box is that normal? internal sounder went off and the strobe on the bell box was flashing Thanks Ray

The PIR is zone 2 that I need to put in the settings then at night how do I set the alarm sorry for being so thick first time ive done this