Search results

Not sure what that is? Nobody has changed anything apart from the fused switch to the programmer when that went. Thanks for all replies, might just sit it out for couple weeks with the emersion heater till new boiler arrives

Hi, thanks for reply. I can't get it to CH only, it defaults to HW so sits either there or in the middle of I set CH on. With programmer set to nothing valve sits at HW.

Hi, it's a baxi Bermuda inset 2. Pilot light on, gas fire works and was serviced recently. If power is on then the valve always moves to hot water and pump always running, even if nothing set on on programmer, if I turn heating on the valve moves across to middle. But boiler doesn't fire up in...

I do have one, but not something I've ever done, so that may be a no!

Hi, by coincidence we had electricians in the day it happened (fuse blew before they turned up) they replaced fuse and it blew again and then changed the switch over. Yes we have a 3 way valve above the pump, this still works, on the controller I can still switch heating on and the valve moves...

Hi, we have a baxi boiler which currently we can't get to fire up. We had the fuse go on the electrical switch for the controller (Drayton LP241) which we then had to change the fuse and then the actual switch itself. After this the boiler was permanently firing up and the only way to stop it...

Just to close this, this weekend we raised the tank by approx. 60cm and this morning the shower was at full strength! Lucky because we had run out of other options!

What also baffles me is how we can get a 3/4 minute window where it works perfectly and then is struggles before and after this

Water tank wasn't drained no. Just turned the restrictor valves for the hot and cold feeds to the shower which are located in the loft. Shower is fitted in exactly the same place. Sorry my plumbing skills are...zero, what would connecting a hose from the mains feed to the hot shower feed...

As far as I am aware the shower was ok before - this is what stumped the plumbers we had over. It was very loud but I put this down to it being an old unit. I don't recall any issues regards to flow when on hot. In terms of it being same specs, I am not sure on this, it was an old Mira...

My wife and I moved into our first house back in October. A couple of months later the shower gave up. This was a fairly old looking mira event power shower so has hot and cold feeds. I bought a new mira power shower for a quick swap and here the problems started. On cold the shower...