Search results

I had already looked at the surewire box but ruled them out as they bring cables flat from every side (not pretty), I would need a number of them, and they would be less workable than even a chock block solution. Which still has its merits on the cost side. I like the look of the DIN rails so...

OK - I have read up on the DIN rail terminals and struggling with choices, there are just so many of them. Single, Double, Triple linked, no linked. I could put in triples so all three connections (L/N/E) for each light are on a single terminal. Thinking this could be really neat with some...

Room will likely have insulation (sound) above plaster board. But if 1.0mm still OK for 8A then I might go for it. I have a lot of connections to make. If it makes the job easier and more importantly neater then great. Dave

Mmmm OK it seems excessive but using LEDs with custom picked low wattages. The room is 8m*6m so 48m2. 11 lights is 1 light per 4m2 but they don't really work like that Decorative Lighting - lower wattages and likely dimmed (2-4W LED) Fireplace - 2 targeted spots Window 1 - 1 targeted spots to...

Great I thought I had heard it was outdated but wanted to be sure. Was only going to do 2.5mm from CU to marshalling point then 1.5mm from there on. Could get 1.0mm but have always used 1.5mm on lighting circuits and I have a roll that should finish this job. Will see if I can get 1.0mm The...

Due to a flooding incident we are renovating the living room. Ceilings have been ripped out and floor above is next! Gives a great opportunity to install some new lighting. Living room is on the large size at 8m by 6m and the lighting design includes 11 ceiling mounted fittings, one 5A Lamp...