Search results

Ok just had a look and its 3 large drawers above the stopcock location so coming into a cupboard at that location wouldn't have been possible. Agree at the back of a cupboard would have probably been a bit easier in case of an emergency but it's not too bad either to pop the kick board off to...

Ok cheers for the suggestions, gives me a few things to look into. PullerGas I don't really see an issue with the tiles as its tiling under a centre island that isn't visible? The centre island was the closest location to where the stopcock used to be as there is now nothing on the wall where...

The visible pipe work at the incoming mains is 22mm. The two fittings at the thermal store below the expansion chamber were actually added at the same time as the mixer valve was replaced. There was leaks at the solder points on the pipe here for the incoming cold water supply to the store...

Cheers for the reply guys. I'm not sure if any of supply pipe work has been reduced. I've attached a couple pictures of the incoming supply, as you can see it's a concrete floor. This was excavated out to re-route the incoming supply to the island location. If anyone could tell me if it all...

Hi all, Hoping someone can help. I have a McDonald Engineers Thermflow Thermal Store in my house. My water pressure has dropped, most noticeably in the showers. Now if I run another tap whilst having a shower the water coming out drops quite a lot and if the bath is to be run, literally no...

Thanks again for the reply. If the VSMART isn't going to work I think I will end up sticking with the existing wiring / stat setup to allow me to get heating back up and running and then look more into the best Internet controlled stat for my setup. One part of the old setup that I am not sure...

Hi Guessman, Thanks for the reply. What controls would work? Preferably a wireless setup. So there would be no way round this to make the vSmart work? I had been looking to get a smart/wifi setup

Hi all, I am looking for some pointers to check everything is being installed correctly by my heating engineer. I am having a ecoTEC plus 428 boiler installed along with the vSmart Controls including the VR66 wiring centre. This is replacing a failed Ideal Icos boiler, Boss Therm wireless stat...