Search results

Thanks, have done that. I just thought there was more to it.

Where can I find panel data backup option before I play too much?

I just will have to set off the tamper to put the cover on as I used the screw to keep it off!

thanks, Just trying to find the backup option for the panel. Found the user account data backup and done that. How do you switch off the alarm after the tamper is set off?

Where would I need to put in the resistor? To part set do you just enter a user code and press the part set button on the panel ( that shows evening set)? Thanks

Are zones set right, Why is keypad not mapped, Zone 8 is not used (or wired) yet it showed a tamper when I checked door contact 2 which is zone 7 Bell shows SCB (not sure what that is) and I wired for SAB (I think) and SCB is not ticked in software

I used the USB com to setup first (didn't realise that you can't just use the ComIP!) Might have the comm settings wrong

Ok, so that is done. What should normal PIR's be set to? I have 2 x panels, what should the second panel be set to? I have set the dipswitches to different so the will not get recognised. What is an ats fault?

I will look at your suggestions! I have not done anything with the bell as yet. Haven't had a great deal of time as Father is old and not well

Thanks for the reply :-) I have used the resistors as you described before the 4.7 & 2.2 together in the PIR's. Part arm I need to use the 2 x door sensors and 1 PIR I am a computer guy and thought the setup would be easy! Just tried to extend a door sensor and tripped the tamper and could...

Gents, Can anyone help me with understanding the programming? I have it connected via ComIP to Wintex software. I am unsure of how to: Classify the types of zones (EOL, 4.7 etc.) Create the part arm section Activate the Proximity tags ( I want to be able to use the tags and a PIN on two...

That's just how I feel lol (bell end!) Will try to change the default engineers code and get a User PIN setup to be able to arm it for now so it is at least working.

ok, thanks Guessing there is a link at the bell. If I can get the Com IP connected I can then program from there. Was trying to avoid the ladders but will have to get them out at some point!

so I can fix that for now by putting the link back?

Done System Alerts Bell Tamper

Done Monitor hardware P A 0 B A L *

Done that and disabled zone 008 Display Yes to select zone setup

Pressed yes and confirmed when asked. display Net RKP > 12.. 1 EXP > 1

right in and now says Net RKP > 12.. 1 EXP > 1