Search results

Hi Polesapart, I watched the first radiator heating cycle this evening, boiler hovers 1.2-1.1 bar on readout then peaks at 2bar before settling back to 1.4 when switched out. No water out from PRV pipe and I didn't hear or see any from the troublesome joint. Even if things are ok I am not...

ummm… no solution then that isn't just another bodge, infuriating how this stuff gets installed and signed off. Hey ho, a rubber bung it is then! cheers, P

Hi folks, Picasso - it could be possible to reroute, but it will still have to go to the internal stack (drilling to outside non starter - leaseholder) I wondered if I connected them to the waste 40mm apart from each other and leave out the bend? Gigz - I did spy a 'bung' too, but was...

Hi picasso, no water at present, but water has been leaking small amounts for some time, intermittent, (triggered by boiler cycle?) we've heard it drip thats how we found it. Almost like it doesn't have enough to 'push' round the trap bend and just weeps over the top? Could that be? Had a rod...

So folks, how do I make it work? Some sort of reducer for the copper to trap top or a re-jig of the whole junction? Every time I go shopping for a solution I just get head shaking and WTF from pros, however I suspect that all our neighbours flats are equally a bit ****e too… We're past our...

Yes, I would have thought PRV to outside too, however can only think because pavement and shops below? New build issues, general build quality leaves a lot to be desired we are finding!

Thanks more pics, unvented cylinder I couldn't tell you, Vokera Linea he boiler has flue to outside all remaining pipes inside, heating & water working fine.

Hi folks, it's taken an age but we've tracked the cause of our knackered floor to what seems like a weird install. Copper pipe 22mm (prv?) and (plastic condenser?) come horizontally 4.5mtrs across the main living space from boiler, the plastic one is fitted into a small 33mm plastic u-bend...