Search results

We have a result. Just done walk test, everything fine. Many thanks to all of you who have pointed me in the right direction.

Doing that now, I have wired all green and whites to zones, just changing contacts around then will do tamper circuit

Ok, that is what I am doing at moment. So on door contact can I wire in tamper? If so how? Thanks

What about door contacts, is that wrong also?

What a schoolboy error. Just wired it correctly on zone 2 and that worked fine on walk test. I will redo rest now and wire tamper

What as in yellow and blue should be where green and white are?

Each time I wire a single zone PIR into tamper, on walk test 1 goes under T and not under zone number, except door contact zones

I am wiring each PIR into tamper 1 at a time. On the 2 I have tried so for on walk test I get this What have I done wrong. I will post pictures of PIR wiring and door contact wiring In following posts

Ok, thanks. I will try this tonight

I have been trying to adjust program. Need to work my way through to see what I need to do. I think I marked all zones as used except zone 8, which is not, but is linked out. System set as timed exit. When I set alarm and exit through door (zone 1). It sets. But none of pir trigger alarm when...

Sorry I was not very clear, the door contacts would have triggered alarm had I not entered code before delay expired. I did walk test, only door contacts registered a 1 on LCD keypad and made sound. All pir as I walked past them did not make sound nor register a 1 on LCD keypad. Red light on...

Ok will test tomorrow night. When I linked out zones 1-7 alarm set but only door contacts triggered alarm. Would this be due to tamper wires or a different reason?

Ok I will try this tomorrow. The one in the tape at the right hand side is for 2. Outside bell boxes. There doesn't seem to be any problems with bell boxes. The fault must be on pir somewhere.

Replaced link wire. When alarm set only door contacts trigger alarm, same as in walk test. Any suggestions extremely welcome.

Been around and checked all tamper wire connections, both on main board and each pir and door contact. Still m Same, comes up as before with tamper lockout.

Right. Progress I think. I have done as suggested, putting in link wires. System sets, upsets etc. So I guess I need to go around each zone and find tamper fault. I have done walk test. On door contact zones 1 replaces 0 as suggested in manual. In pir zones 0 does not change to 1 even though pir...

Ok thanks. I will try this Sunday morning. I will post update when I have done this