Search results

  1. A

    Chaff 100

    Got A problem boiler not sparking changed air pressure switch no :( joy. Fan is ok dont think pump running any ideas
  2. A

    BRITTONY SE80 POWER PROBLEM

    gOT a BRITTONY SE80 EVRY TIME IT FIRES UP IT TRIPS RING MAIN. RING MAIN OK TESTED FOR INSULATION, POLARITY ETC. ANY TIPS ON WHERE TO START ON BOILER RECENTLY HAD A NEW PCB. OBVIOUS POWER PROBLEM SOMEWHERE NOT SURE WHERE TO START. PCB :cry: 2A FUSES OK NEVER BLOWN
  3. A

    chaff brittony 2t

    replaced a diaphgram in a brittony 2t is it supposed to have a gasket as well as its now leaking. It has a water section repair kit in place and the body is brass. But didn\\\'t seem to have a gasket when it came off! Just a worn rubber diaphgram
  4. A

    Chaff SE80

    Attended a Breakdown of a Chaff SE80 Symptoms:Locking Out No sparking. Cleaned Fan up cleaned all terminals around APS as plastering recently carried out, carried out a full clean up got going ok CH & DHW Temps ok left running for a couple of hours no problem. Been back 3 times same problem but...
  5. A

    noisy boiler

    got a Worcester 24CDI CH OK When in DHW mode boiler makes a banging noise suspect air, but flow rate & Temp ok, pressure gauge fluctuates wildly
  6. A

    noisy boiler noise in DHW mode

    Hi All, got a Problem with a Worcester 24cdi every time i call for HW a loud banging noise coming from boiler. i,m thinking air! CH OK No banging. or do you think blockage in Sec Heat Exchanger :?
Back
Top