Search results

Hi thanks for the replies, I managed to make it work, as above - the 2 red wires (Live) to L, and each black cable to the the relevant L1 and L2.. Great solution to my problem. Thank you.

Hi, Sorry for the delay in following up on this thread. I have purchaed the aqara 2 gang zigbee switch (without neutral) but would appreciate a little more help after inspecting the original swithc The original switch, is a 2 gang switch (operating the kitchen lights and an old external light)...

Thanks for the options, both of which I need to explore to understand more ... In thinking about the zigbee solution - I stumbled across "Aqara Smart Wall Switch" that appears to not require a neutral wire? (but does require a hub) and wondered if anyone has any experience? Thanks again..

Thanks, much appreciated. So my only option is to either replace the whole fittings (assume not cheap to replace) or move the switch to a more convenient location... Thanks again..

Hi, I thinking of replacing some existing blubs in a series of downlights in in our home and replace with a set of wifi enabled bulbs and would appreciate some advise please.. The main reason to replace with wifi enabled bulbs is due to the placement of the light switch which is not...

Stem, Just to finish off this thread, hive installed and appears to be working correctly - many thanks for your help! There was a delay in installing due to a failed 'air pressure switch' on the boiler which needed to be repaired beforehand... Thanks again..

Stem, Many thanks for the advice. In looking at my setup, I suspected the thermostat wire was the 4th from top (in the junction box image). From this, the yellow wire goes to the white wire from the 3 port valve. The red wire is connected to a yellow which appears to go back the controller...

Many thanks for the responses. From what I can see the thermostat cabling goes from the junction box, down underfloor and then chased into the wall, is there any way of checking? The other 3 cables (top) of the junction box go into the loft space and towards the boiler mounted in the kitchen -...

Hi, I am planning on installing the hive kit to replace my conventional boiler and thermostat setup. Before I start would appreciate some help running through the approach. The current system is a glow worm 60ff linked to a lifestyle LP241 controller and RS1 room thermostat. Pictures of the...