Search results

  1. K

    Pyronix enforcer V10

    Hi folks, I've got a v10 pyronix enforcer panel that I installed last year, I understand there is a newer V1.2 or similar firmware version available. Basically, I want to add an external pir xdl12tt-we sensor, To put in the garden and one aimed at my van on the drive. All I need is a function...
  2. K

    Pyronix enforcer v10 queries

    Thanks, I think I'm nearly there, The answer to the problem I think was devices set to "all" or "any" The entry timer now works and the hall pir seems to be ok. I'll check everything later as was too late last night to fully test it. The bell module, isn't set up at all yet. My last alarm was...
  3. K

    Pyronix enforcer v10 queries

    Ok, So I just set the door switch to 07 and only area A.......and the countdown timer started :-) I had already checked for double knock and normally open by the way. Have I got the right end of the stick with programming sensors ? for instance if you enabled one for A B C and D, If you set...
  4. K

    Pyronix enforcer v10 queries

    Well, when I set up each device, I enabled them for every area they were going to be used in for instance garage would be A,B,C,D to be active in all modes and say the upstairs landing would be A C and D for night mode. I've got the panel on level set ? so once you put the code in, it asks...
  5. K

    Pyronix enforcer v10 queries

    I've got the door contact set for A B and C D is for garage and workshop only So, shall I leave the door contact on 07 and the pir on 08 ? I've currently disabled the pir so I can eliminate this non entry timer problem. Thanks
  6. K

    Pyronix enforcer v10 queries

    Hi folks, I recently bought and installed a pyronix enforcer system, added 2 wired keypads the system works fine on all my "06 inputs" but my door entry, although It chimes ok and on the app it appears as working, I can't get the entry timer to start ! Have tried all manner of settings but no...
Back
Top