Search results

Hi Sparkymarka, 9448. 30/12/18. Now, Zone 3 omitted, System activated Zone 3 LED comes on, disconnected Sensor, seems O.K.(going N/C) PCB?

Hi Guys, thanks for all the help (and patience). Good news, it turns out the problem was a high resistance contact on the panel's PCB mounted Anti-Tamper switch, I have temporarily shorted this out and the system now works as it should. Regards.

Hi, thanks. I'll try this (tomorrow), thanks for all the help. Regards.

Hi, linked out A/T terminals, set alarm and Tamper Light still comes on (as before).

Hi, when full alarm set, Tamper Light (only) comes on.

Hi Sparkymarka, sorry forgot to mention, the LED light on the IR Sensor comes on when movement detected and then goes off when not be 'blocked'. Regards.

Hi Sparkymarka, did as you requested, no change, no alarm lights came on and no panel noise.

Hi Sparkymarka, sorry for not replying sooner (been out). By unset do you mean omit?

Hi Sparkymarka and The Pars. Sparkymarka, once I have entered the User Code there are no alarm LED's on, the Tamper LED only comes on (solid) when I try to omit either Zone 2 or 3. The Pars, thanks for the information, I'll try this. Regards.

Hi Sparkymarka and Handymanjo. Sparkymarka, the current fault is the same before I fitted the new IR Sensor, nevertheless I've checked the wiring and the new IR terminal layout and they are the same as the original IR Sensor. Handymanjo, how do I carry out a Full Reset? Regards.

Hi Handymanjo, thanks for replying so promptly. When the panel is closed and the User Code is entered the Panel Tamper Light goes off but when Omitting Zone (3) the Panel Tamper Light comes on (solid) again.

Hi Sparkymarka, The Pars, or anyone else. Please see the above threads. I have now replaced the old battery with a new one but the Panel Tamper Light still comes on, I have a copy of the Installation and User Guide and assume the problem is the Anti-Tamper on the Bell Box, (I've operated the...

Hi Sparkymarka, I thought, (wrongly) that the panel buzzes continuously NOT intermittently when Zone (3) is omitted, but from what you say isn't a fault as the panel DOES buzz intermittently when Zone omitted. Thanks for the help. Hi The Pars, I have now checked when the battery was changed...

My 9448 which has (up until now) been very reliable, however when I set the alarm to omit Zone 3 instead of the usual continuous 'buzzing' sound it sounded an intermittent 'buzzing' sound and the Zone 3 LED on the panel flashed, I opened up the panel to see if there were any loose connections...