Search results

thanks for explaining that, so is there a specific type of garage door (controller) that is required or if i was to get like a roller shutter door then this could be operated using this function? What about distance?, my garage is 50m away do you think i will have an issue? is there a way to...

Could you explain a bit more as i am just a beginner.

Hi all I know the alarm system can operate garage doors and various accessories. Its something id like to do in the future. How do you go about doing this? What accessories do you need? How do you set it up? any help will be appreciated.

It was fine - i read the manual quite a bit to get my head around what options there was and to give me an idea on how i wanted to setup the alarm. I had a few issues which people on here helped me with but i managed to get it up and running almost straight away.

Thats great to know thankyou guys.

Hi all Recently installed an Euro 46 V10 panel. As I was renovating a house I decided to wire all sensors initially. Hopefully In the near future I will be building a garage but the only downside is the length of the garden. I have been told the garden is 127Ft not measured it myself s of yet...

Followed the above, Got the system working a treat, thankyou for your help.

Awesome thankyou. I'll give this a go tomorrow

How do I change the keypad settings?

What i want is area A for full set and area B to set all down stairs but leave ones sensor unset (upstairs). So would i set inputs 1-3(downstairs) as A+B and input 4 as A only?

Hi all Just been trying to program the areas on the Euro 46 V10 system and im getting totally confused. I have 4 sensors sensor 1-3 downstairs and 4 upstairs The manual states area A full set and area B upstairs. Going through the manual i choose the input, e.g 01 - then input type e.g...

Sorry all just tried again yes I type the code in and get the enginner menu. God knows what I was doing wrong initially.

1111 is a default engineer code that I know , I have not set the system with any code as it's the first time it's been switched on and I have not programmed any user codes

Ok will give that a go although I'm sure I've tried it and the code stayed on screen as ****and then went back to the main screen.

Issue resolved - this was a faulty unit - system had been replaced

Hi all managed to install system today. I have connected to the system 3 x Pir`s and 1 door contact. 1 x 16ohm external speaker connected to the system 1 x Keypad connected to the system. 1 x Lan card connected. I turned the system on for the first time there were no sounds and the keypad...

Hi all Right, i have checked the continuity of all fuses and they all work especially the one called BUS. Below is the rear of the keypad and a pic of the main panel.

Ok will do. I did have a look and all looked ok but will check again.

From the speaker that is a conected there is a beep....beep...beep tone which lasts for 2 seconds at a time.

I have tried that and there is nothing. They key pad dont light up nor says anything. I measured the terminals at the board and there is no voltage. I have also powered it down and back up and still nothing.