Search results

any recommendations. the place im getting the floor is charging £10 a litre!! bit rich for me! what should i use and where should i get it? Many thanks Jon

hi all, i have a non pressurised system. boiler downstairs, tank and pump upstairs. i have no TSV's in the house - all are pegler standard valves. One rad in the kitchen is cold the rest are very toastie indeed! the pipe going into it is hot but the pipe coming out is cold. i have...

answer found, please delete, thanks.

hi all. I going to be installing solid wood flooring soon in my living room / hallway. the house has a concrete floor which is nice and dry and in good condition. in the hall the front door step protrudes about 2 - 3" into the room. the hall is about 1ft above ground level. The...

hi all. I am looking to take out a 4.5 load bearing wall, to be replaced by a UB. the wall coming out is single brick. I know there are lots of factors involved but roughly what shoud i be paying for it to be done? Thanks in advance. Jon

Hi all. I have had a Salus RT300RF fitted today. all was great until the programmer stopped then restarted later for my evening cycle.... then it seems that the sender unit wouldn't connect to the reciever unit.... the only way i can get it to do it is to turn the heat down on the stat to...

hi folks, my dishwasher is having a bit of a strop! It starts its cycle, counts down, and then stops halfway through a cycle. the display turns off and wont turn back on. I leave it for about half an hour then switch it on and its fine. it always has water inside when it stops, (usually about...

hi guys. complete amateur here!!! my problem is this! I have bought my first house (hoorah) but have some central heating and hot water probs. :( First is that there are no cylinder stat or room stat which in the winter was chuffing expensive!!! there was an old prgrammer which i have...

hi guys. first post here and well and truly stuck at the first hurdle!! i have a Randall 102 programmer controller. it isnt the Danfiss one, i guess it is from before they bought out Randall. my first problem and question is. will the programmer swap for a like fior like one. eg danfoss...