Search results

(was the spray head part)

I think I found out but can't delete the post...

Does anyone know what this is that came with a dishwasher? Looks like a spray replacement or something.

thanks Terry. So just dangling in there a few inches? I'm doing a test rinse now. I gave up on that valve and just using the new setup with the T valve I installed. Could've saved about £40 by paying a bit more attention. lesson learnt

Thanks. How do i make the hose a tight fit? Won't odours come back up otherwise? - the water valve is really tight. I'm breaking the plastic trying to turn it. (turning it the correct way)

Terry. You'll never believe it. After all that fuss I found this in the cupboard next to where the new dishwasher would go. Can you tell me what waste hose would fit this standpipe? I'm guessing that's what the standpipe is for.

ok, after spending money and spending ages re-sorting out the pipe work under the sink, i've discovered there was already a waste pipe and water valve ready for a new dishwasher installation... BUT 1. The valve is not opening. Do these levers lock? It's in a new-build flat and looks untouched...

Is it hard to remove the valve correctly? Do I need to add any putty or something?

ok thanks for your help Terry, I'll go for your original suggestion.

What's the best way to turn this into a tee / Y so that it can feed both a dishwasher and washing machine? This would be the replacement right? https://www.screwfix.com/p/compression-appliance-tee-brass-x-x-15mm/24030 Will that screw directly onto the existing valve? Thanks

I meant: to replace the part that the arrow is pointing to. They look like the same size no?

How about this? Oh is that too high? https://www.screwfix.com/p/mcalpine-v33s-compression-domestic-appliance-tee-piece-connector-white-40mm/4167p?_requestid=442934

Ah dammit. Ok thanks. The replacement you said: " Space saving P trap". looks quite wide compared to our existing setup. Do you think it will fit?

I found this one: https://www.screwfix.com/p/mcalpine-twin-hose-connector-40mm/206hr Looks like it could fit the bill? Is it recommended to use any solvent or putty etc?

Thanks Terry, Isn't there a way to just replace this bit with a Y / tee piece? Otherwise I'll go for the one you mentioned.

Ah, thanks. Please can you point me to this second spigot? Would it be a tee / Y or another pipe coming out? I can't find the bit. Thanks

Hi, I'm after a bit of advice before installing a new dishwasher. - Is this the Y piece I need for the waste water? https://www.screwfix.com/p/washing-machine-y-piece/81000 Lots of people are saying it leaks. Is there an alternative? - Do you use any sort of solvent cement or something for...

We need to replace a Gledhill PulsaCoil A-Class thermal store. It has cost lots of money in repairs so ideally we don't use a Gledhill product again. Are there good alternatives? Also - is the A-class unvented or vented? Why would we choose one over the other? (we are in a flat and the...