Search results

Just updating this. I flipped the rubber gasket on the flush cartridge and got it all working.

Yes probably should have done that at the same time. I might get lucky and just be able to replace the flush cartridge. For the time being I’ve flipped the washer over.

Float is now gone and replaced with flomasta. Now on to the next problem.

right so I replaced the whole thing with a flomasta. Had to take the cistern off as the valve flow bolt was recessed under the cistern and near impossible to access. Put everything back, checked for leaks and cistern was filling up properly and float worked. BUT no sooner had I screwed...

Here we go. Replaced it, lined it up etc but the float doesn’t do anything

Arctic Hayes Siamp Diaphragm Washer 29mm  It literally is identical

Wonder why that is. Even on the video it says it fixes 7 out of 10 times. Will try replacing the valve. It’s going to be fiddly getting up and under the toilet!

Thank you for the video- very helpful. The arm and valve are in the right place but definitely raising the float either by letting the cistern fill up or doing it manually doesn’t stop the water. It was a new valve from screwfix. I briefly swapped them back and the float worked again only to...

Got the valve this morning in and replaced it. Saw the old one was shredded and popped the new one in. Now the cistern keeps filling beyond the float even though the float moves up when the water reaches it. Can’t figure out why it’s not shutting off?

I had a fiddle as all of a sudden the water kept running. Shut the water off, turned the plastic white anticlockwise and opened up the water supply. Filled much faster and touch wood not overfilling. Going to get a replacement part just in case.

Cheers for the quick reply. Any advice on how to pop the top off the valve?

Morning all Appreciate there are a few posts on this but recently I’ve noticed that the cistern is taking ages to fill up. The supply is fully open so it must be the flush valve. When it fills up it’s more like a fine spray than a steady flow of water. It does stop filling though. Any...

Tried a new o ring but still leaking. Will try some grips just in case it can be prised apart. On the positive side this part is only £83 on Amazon

Right. Found out why it’s such a faff.

Good news and bad news I got the hose off- never seen an attachment like that before (see photo). Problem is that I can’t pass it up though the hole/fitting. I’ve removed everything now and replaced with a spare hose but can’t figure out how to get the old one back through the fitting. I can...

It was just a hole cut into the bath as there are no taps. All was good until the end of the hose started leaking down through the hole into the floor!

That does look like the part. I’m going to have another poke around tomorrow. There is an ‘outer’ part of the shower hose that screws on to the exposed thread you can see. Will take another picture if I can’t get the hose out. Hopefully it won’t involve taking everything off the wall as it’s...

Afternoon all Unfortunately the shower hose in the bath is leaking where the shower head attaches. I tried replacing the O ring but that didn’t help, still water pouring out and back down the pipe. Not the end of the world to replace the hose but I had to remove the bath panel in order to...

Thanks. Couldn’t see a thing on status codes but now 70 C

Now it has suddenly sprung to life and the temperature has shot up. What an earth is going on?!